Hi, comrade
![Smiley :)](https://forum.itoosoft.com/Smileys/default/smiley.gif)
Well, nice work! Your progress is noticeable!
I don`t have time to test it thoroughly but what I have noticed in a few seconds:
- when the clipping area is larger than approximately 230cm you have a problem with X evenly section
- since your handle is a separate segment I would go with additional Transform at the end to control Y Translation so if the window is too high you can control position up/down
-
![Angry >:(](https://forum.itoosoft.com/Smileys/default/angry.gif)
you can`t open the window!?
![Grin ;D](https://forum.itoosoft.com/Smileys/default/grin.gif)
- you need the depth control to accommodate different wall thicknesses (but this is 18 more segments to work with
![Cool 8)](https://forum.itoosoft.com/Smileys/default/cool.gif)
)