Itoo Software Forum

Author Topic: Railclone Shutter  (Read 2291 times)

NathP

  • Newbie
  • *
  • Posts: 5
Railclone Shutter
« on: September 13, 2022, 10:35:41 AM »
Hello,

I try to create shutter in RC.

I used an Selector for 3 positions: ID1 Radomly open/ ID2 Open/ ID3 Close.

I created 3 Generators, the first for the structure, with 2 translations Xoffset (3cm for the start, -3cm for the end).
the second for the left Shutter at the start and the last one right shutter in the opposite value, i tried to made all shutter in the same generators but with the mirrors one shutter go in the wall.

I would like to use expression for Xoffset, how can i tell to RC "when i put 10cm in the Xoffset do -10cm for the seconde generator" ?

Thanks

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2831
Re: Railclone Shutter
« Reply #1 on: September 13, 2022, 01:10:40 PM »
Hi,

You have a couple of options. You could simply multiply the value by -1 to create the inverse, or you could use the Negate Value macro found in Macros > Arithmetic > Negate Value.



I hope that helps,

Paul.
Paul Roberts
iToo Software

NathP

  • Newbie
  • *
  • Posts: 5
Re: Railclone Shutter
« Reply #2 on: September 13, 2022, 02:00:30 PM »
It help me very well!

Thank you so much Paul!

Nathan