Itoo Software Forum

Author Topic: Advice with a Tiled Floor  (Read 100 times)

Lee H

  • Newbie
  • *
  • Posts: 13
Advice with a Tiled Floor
« on: May 23, 2022, 01:02:17 PM »
I have a tiled floor i need to create as per the image attached.

The version i am working on seems to be close, it is still wrong and i cannot understand how to fix this.The pattern has to be a mirror of the colour. Black against White, on X its fine but Y isnt

Any ideas ?

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2567
Re: Advice with a Tiled Floor
« Reply #1 on: May 23, 2022, 01:17:06 PM »
Hi.

It looks like you're nearly there. Try the following

- Clone the existing Sequence node and swap the order of its inputs
- Wire the two Sequence nodes to a third Sequence node and then connect that to the Default input
- Change the 3rd Sequence nodes Mode to Increment on Y.

I hope that helps.
Paul
Paul Roberts
iToo Software

Lee H

  • Newbie
  • *
  • Posts: 13
Re: Advice with a Tiled Floor
« Reply #2 on: May 23, 2022, 01:31:08 PM »
Legend - thankyou