Itoo Software Forum

Author Topic: Crash on edit spline L2S generator  (Read 228 times)

GT4505

  • Jr. Member
  • **
  • Posts: 59
    • claar.be
Crash on edit spline L2S generator
« on: August 01, 2017, 01:56:26 PM »
Hi,

I've made this rc object with closed splines and an L2S generator in auto align mode.
Not always but quite often when I move some of the splines in edit mode max crashes.
Is this a known issue? Can I prevent it from happening?

Pieter van Stee

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1396
Re: Crash on edit spline L2S generator
« Reply #1 on: August 01, 2017, 03:19:29 PM »
Hi,

Sorry to hear you're facing these troubles. If you'll be able to reproduce it on a minimal scene, which you can send us, it would be great. Thanks in advance for any further comments on this issue you can share about it with us / our user community.

Best regards,

GT4505

  • Jr. Member
  • **
  • Posts: 59
    • claar.be
Re: Crash on edit spline L2S generator
« Reply #2 on: August 02, 2017, 04:34:53 AM »
Hi Michal,

I will try that later on this week.
It didn't occur every time but usually when dragging rectangles over each other with the spline in edit mode.

Thanks for the reply.
Pieter van Stee