Itoo Software Forum

Author Topic: Manual rotation/twist along spline  (Read 282 times)

OL5007

  • Newbie
  • *
  • Posts: 2
Manual rotation/twist along spline
« on: September 26, 2018, 07:02:18 PM »
Hi there, i try to create a simple hollow slide along a spline. My problem is as the spline changes it's direction the hollow profile should change it's rotation like a twist, just for a certain distance. Then if it comes to another curve it has to be rotated again etc..  It would be great if it would work a bit like the loft compound with it's graph based twist controller. Is there a way to achieve that?
By the way, I tried manipulating the spline handles, but this is very limited and it changes the splines shape. So i don't know any other way to rotate knots of the spline itself.

Maybe the pic illustrates my problem more clearly ;)

https://imgur.com/a/b4A7UUX

Thanks a lot for helping!
Best,
Sascha

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1483
    • iToo
Re: Manual rotation/twist along spline
« Reply #1 on: September 27, 2018, 05:21:57 PM »
Hi,

Thank You for the question. Unfortunately with current RailClone version there is no possibility to control this. This feature is in our todo list.
Rokas
iToo Software

OL5007

  • Newbie
  • *
  • Posts: 2
Re: Manual rotation/twist along spline
« Reply #2 on: October 01, 2018, 05:37:15 PM »
Oh, ok - so i'm looking forward to see it in the next version  ;)

Best,
Sascha

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1483
    • iToo
Re: Manual rotation/twist along spline
« Reply #3 on: October 01, 2018, 06:50:44 PM »
Probably not in next, but in some future version.
Rokas
iToo Software