Itoo Software Forum

Author Topic: Negative padding  (Read 326 times)


  • Full Member
  • ***
  • Posts: 172
Negative padding
« on: January 29, 2020, 08:56:56 AM »
I have a style made of 2 segments across 2 L1S generators.
Segment B is laying right on top of segment A, and each one of them is controlled by a separate generator.
A spline stretches both of them equally. Which is fine.

But, I need segment B to stick out a bit over the start and the end of the spline.
I know segment A can be padded and be done with it, but the thing is - segment B is just a decoration and I cant to plan the entire thing based on it.
Like this.


  • Hero Member
  • *****
  • Posts: 802
Re: Negative padding
« Reply #1 on: January 29, 2020, 09:32:08 AM »
I can`t see the problem with negative padding.